SMARTROOF METAL ROOF SHEET is a steel sheet with an organic coating. There are many kinds of it: veneer, color steel composite board, floor bearing board, etc., and it has the characteristics of light weight, heat insulation, high strength, bright color, flexible and fast installation. Such a good color steel plate how do we do care for it!
SMARTROOF METAL ROOF SHEET Dry for 2-3 hours and then apply the ice paint again, and then apply the second time after 3 hours. Foam plugs can be used to fill waterproof adhesive paint twice at the joint trough between ridge tile and roof tile edge plate to prevent water seepage and flooding. Remove the protruding part of the steel plate and seal it with silicone glue to make the joint of the plate neat, and the construction surface should be dry and clean. When the gap between the joints is greater than 5mm - 30mm, if you need to strengthen the adhesion, please add 1 layer of alkali-alkali polyester cloth; Apply the waterproof paint for the third time in 3 hours.
SMARTROOF METAL ROOF SHEET is first coated with rubber paint base, and then covered with alkali-resistant polyester cloth, and then coated with waterproof rubber paint. The rivets and self-tapping nail eyes can be directly coated with waterproof adhesive paint by brush four times, with a thickness of about 1.5mm and a diameter of about 50mm. The next coating shall be subject to the non-stick hand of the previous coating.
Contact:Smartroof
Tel:0086-757-83128353
mail: smartroof@fswinning.cn
Address: Room H, 30/F, Foshan Development Building, No.13, East Hua Yuanrd, Foshan, Guangdong, China
Tel: 0086-757-83128353
E-mail: smartroof@fswinning.cn felix@fswinning.cn
Website: https://www.smartroofasia.com
EN
ES
