Shingle edge is an important procedure in the production of SMARTROOF METAL ROOF, its success is directly related to the quality of the shingle. The trimming process is generally implemented before the tile is positioned, but some people prefer to implement the trimming work after installation. However, if the edge is closed after the work, it is necessary to leave enough space for the edge before, otherwise, the space is not enough to close the edge.
SMARTROOF METAL ROOF closing process is relatively simple. When the edge is collected, first of all, the edge tool is located on the tile chassis, pay attention to the distance between the tile and the tile, and then use the tool to hold the end of the color steel tile, the tile chassis fold up. In the process, when the board is used on the roof with a slope of less than one fifth, the bottom end of the shingle is slightly bent downward, so that when it rains, the water can flow out smoothly.
Through the content explained in the article, you can generally understand the specific content of SMARTROOF METAL ROOF edging process, the use of a product should fully understand the product knowledge of this product. I hope the content explained in this article will be helpful to you and will have practical significance in the future operation and use.
Contact:Smartroof
Tel:0086-757-83128353
mail: smartroof@fswinning.cn
Address: Room H, 30/F, Foshan Development Building, No.13, East Hua Yuanrd, Foshan, Guangdong, China
Tel: 0086-757-83128353
E-mail: smartroof@fswinning.cn felix@fswinning.cn
Website: https://www.smartroofasia.com
EN
ES
